Panasonic Portable CD-Rom Player KXL-810A - Manual (Page 34)

Troubieshooting
Trouble Possible Cause Solution
"no disc” message
appears on player’s
display even after
inserting a CD.
Sound skips, or data
can not be read.
The player or/and CD are
damp or moist, because the
player or/and CD may have
been moved from a cold place
to a warm place.
Remove the CD from the
player and do not use the
player and CD for about 1
hour.
You can not listen to
sound coming from
the PHONES jack of
the player. Headphones are not
connected.
Connect the headphones to
the PHONES jack firmly
(i^ P. 11, 18,21).
The player’s VOLUME control
is set to “0”.
Set the player’s VOLUME
control to a higher level
(0^ P. 11, 18).
■ When the computer’s sound
system and the player’s
PHONES jack is connected:
the volume is set to the
lowest level in the “Volume
Control” or “Mute” is
selected on the software
control of the sound device.
Set the volume higher level,
or cancel the "Mute”
selection.
For further information refer
to your sound device manual.
CD does not stop
rotating, though
is pressed.
Data is being sent from the
computer {POWEFl/BUSY
lamp is blinking).
Exit the software you are
using with the player, then
wait until the POWER/BUSY
lamp stops blinking.
An audio CD is
inserted and the
power is on, but
buttons on the player
do not function.
When the player is connected
to the computer. .
q , q
or «x-tO is pressed.
When the player is
connected to the computer,
these player’s buttons do not
function (osr P. 12).
System lockup. Press RESET switch
(ET P. 11).
The player cannnot
be turned off.
Tried to turn off the player by
using the power switch when
the player is used with the
power from the computer.
When the power from the
computer is used, the power
switch does not operate to
turn off the player (cgr P. 29).
System lockup. Press RESET switch
{o^ P. 11).
S is pressed, but
the power is not
switched to the power
from the computer.
' q is pressed when
POWER/BUSY lamp is
blinking or player’s terminator
is set to ON.
Press when
POWER/BUSY lamp is not
blinking or set the player’s
terminator to OFF.
34