Panasonic Portable CD-Rom Player KXL-810A - Manual (Page 16)

Preparation
For desktop computer with SCSI board
Step 1 Connection
A commercial SCSI board and SCSI cable are required to connect the player to a desktop
computer without PCMCIA card slot. For a recommended SCSI board, refer to “Option/
Recommended Products” P. 39). For further information, refer to your SCSI board
manual.
First make sure both the player and the desktop computer are off.
Cautions for a SCSI cable:
• Use a shielded SCSI cable of 1.5 m (4.9 ft.) or shorter.
•The connector connecting to the player should be half pitch 50 pin (pin type). Refer
to your SCSI board manual for the type of the connector connecting to the computer
side.
Step 2 Setting up your desktop computer
To use the player with your desktop computer, you must set up your computer. Please
refer to the enclosed Setup Manual.
■ Daisy chain connection:
You can connect this player to other SCSI devices (up to seven devices). Make sure that
each SCSI device has different SCSI ID number.
For the setting of SCSI ID number and terminator of this player, refer to “SCSI ID Number
and Terminator Setting” ((B^ P. 36).
Since the player has only one SCSI connector, it must be the last device in the daisy chain.
In this case, set the terminator of the player to ON (E^ P. 36) and of the other SCSI
devices to OFF.
16