Panasonic OMNIVISION PV-S9670 - Manual (Page 11)

‘Important: If the remote control POWER, ACTION, PROG, CH A/T, INDEX/ M/A SKIP, NUMBERED keys,
INPUT, TAPE POSITION, or ADD/DLT button does not work when pressed, press the VCR button
on the remote and try the button again.
Alternate Instructions
complete steps below if any of the following applies:
• Selected connection type B (VCR ► CABLE/DSS BOX ►
TV or VCR ► TV) in step 4, page 8.
• Selected “NO REMOTE” in step 6, page 9.
• Selected “YES” with DSS receiver in step 8, page 9.
1
CHANNEL/CLOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX, TUNE I T TO YOUR
LOCAL PBS CH THEN. . .
PLEASE PUSH CH UP KEY
Start Channel Auto Set
and Clock Auto Set.
• The following messages appear.
“CH AUTO SET PROCEEDING”
“AUTO CLOCK SET PROCEEDING"
2
1/ 4/2000 TUE 12:00PM
DST:ON
SETTING : CH 02
AUTO CLOCK SET
COMPLETED
END : PUSH CH UP KEY
Confirm that time Is
correct.
Press CHA
to exit.
Clock Setup Incomplete...
Set the clock manually.
a) Press ACTION.
AUTO CLOCK SET
IS INCOMPLETE
PUSH ACTION TO SET CLOCK
SELECT MONTH
SELECT:A ▼ KEY
SET :► KEY
END :ACTION KEY
---------- SET CLOCK ------------
1/ 4/2000 TUE 12:00PM
DST:ON
ET COMPLETED
SET :•< ► KEY
START : ACT I ON KEY
b) Press AT to
select month.
c) Press ► to set.
• Likewise, set date, year, time,
DST (Daylight Saving Time).
To Make Corrections,
repeatedly press ◄ ► to move
to error, then correct.
d) Press ACTION.
(Clock starts.)
• To exit this mode,
press ACTION again.
SELECT/
SET
A:PLAY
T iSTOP
◄ :REW
► :FF
ACTION
CHA
If you use a DSS receiver, it must be turned off.
If displayed time and DST are incorrect...
If you use cable box and receive more than one PBS station, try auto clock set again
entering the one you have not tried yet. (See “Clock” on page 42.)
If you happen to live close to two time zones, VCR may have recognized PBS channel (setting channel)
in the wrong time zone. Please do the following to correct the situation.
1) Make a note of SETTING ; CH number shown on screen and press CHA to exit,
2) Delete the channel from VCR memory. (See “Add or Delete a Channel” on page 43.)
3) Press ACTION to display the menu.
4) Press
AT to select “SET CLOCK,” and then press ► to display the SET CLOCK screen.
5) Press AT and ► to select and set “AUTO CLOCK SET.”
6) Follow One Time VCR Setup instructions on page 8~11.
• If you use cable box and have multiple PBS stations, tune cable box to a different PBS station and try
auto clock set using the menu.
11