Panasonic DVD-A360A - Manual (Page 45)

S'ft m
Mo SLibIftles, ^Subtitles appear only with discs which contain them.
■Subtitles are cleared from the TV monitor. Display the aubtitles.
27
Altemativa aucQo soundtrack {or
subtitle) languages fail to be select­
ed.
■An alternative language is not selected with dfecs which do not contain mors
than one language.
•In the case of some discs, the alternallve language cannot be selecled by
operating the AUDIO or SUBTITLE button. Try eelecting It from the DVD
menu tf one is available.
29
Angle cannot be changed. This funcllon is dependent cn software availability. Even If a disc has a
number of angles rsoorded, these angles may be recorded for specific scenes
only (when “ANGLE" lights Up on the player's FL display).
—
Play does not start even vrhen title Is
selected.
Confirm, the "2 Ratings" setting. ^ 31
Audio soundtrack andr'cr subtitle
language is not the orte selected at
the Initial settings.
]f the audio soundtrack andror subirtlo language does not exist on the disc, the
language selected at the Initial settings will not bo soervheard.
The menu is ctisplayed In French
(example). The setup "3 Menus’ of "1 Disc Languages" is sot to Frertch: select English. 31
NO sunourui eound. ■Choose the setting at "3 Speaker Setting" which matches your speaker
system.
•No surround sound is output when Ihe virtual surround effect Is aoUvatod
(*VSS 1", “VSS 2", “Headphone VSS r or “Headphone VSS 2"). Select
“VSS OFF' or "Haai|)hgne VSS OFF.
37
23
The password for rating level hee
been (orgottert.
Reset all the settings to Factory
Preset
While the player le In the step mode, hold the player's SKIP (i^) button and
the PAUSE button down simultaneously and then hold the OPEMfCLOSE
button down for longer than 3 seconds (until '“Initialized' disappears from the
TV mrytltor).
All initial settings wili return to the default values. If you have eelected Tock
Air in "2 Ratings", you must remove the DVD from the player before
performing this operation. {See the note at the foot of page 30.)
30
No m^u play. TM6 luncticn works only for Video COe with playback control. IS
J'-.! J. •!.. s
When an error or trouble le detected duing operation, a service number appears In the PL display.
\i№en a sorvbco nurnber has appeared, check cut the details given below.
Service number Player status nemedy
un
Disc is dirty. wipe the disc clean.
Hnn
D G efantfs
for a number.
Trouble Is likely to have occurred. The
number follo'wing IH" depending
on the status bf the player. Press POWER ((¡)) to eat Ihe player to the standby mode and
then back to ON. Alternatively, press POWER (6) to set the
player to the standby mode, disconnect the AC cord, and then
reconnect it.
'S
CE
»If trie service number fails to bs cleared evert when remedial acticn Is taken, ask a service technidan to repair the player.
4S