Problem, Cause & remedy, Answering machine – Panasonic KXF120 User Manual

Page 52: Troubleshooting guide, Cont.)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Troubleshooting Guide

(cont.)

Problem

Cause & Remedy

ANSWERING MACHINE

The unit does not work when I push buttons.
I cannot remove the cassette from the unit.

Push the RESET button, (found on the bottom of the unit)
If the unit does not operate properly even if pushing the
RESET button, unplug the AC cord and then plug it in again

after 1 minute.

The unit has been set to the Automatic Answer
mode, but no Incoming Messages have been
recorded.

•The microcassette is broken (cut, worn out or twisted) or

not inserted. Replace the cassette with a new one.

•The OGM is recorded improperly. Record a new OGM.

•The AUTO/FAX selector is set to the “FAX" position.

Change the selector to the “AUTO” position.

When the tape Is played back, the sound level is

low, even If the SPEAKER VOLUME control Is

turned up fully.

Clean the heads. (See "Maintenance" on page 17 in

INSTALLATION MANUAL.)

I have played back all the recorded messages
and I want to record the next phone call after the
last previously recorded messages.

When the AUTO ANSWER indicator starts blinking, wait for
7 seconds. When the AUTO ANSWER indicator is off, push

the AUTO ANSWER button. The unit will be ready to record

next phone call.

1 push the buttons of a remote phone, but the
unit does not respond.

\______________________________________________

•Make sure that you are using the correct code number.
•Record the Outgoing Message in a quiet place.

J

r

Some Incoming Messages have not been fully
recorded.

V_____________________________________________

Set the CPC to “B". (See “Initial Preparation" on page 8 in
INSTALLATION MANUAL.)

J

The unit does not ring.

L

_____________________________________________

•The RINGER VOLUME selector is set to “OFF". Should be

set to “HIGH" or "LOW".

____________________________________________________ )

The caller suddenly cannot hear my voice
during a conversation.

V_____________________________________________

Look at the MUTE indicator. If it is lit, push the MUTE button

to resume the conversation.

___________________ ^

4-4

Advertising