Panasonic KX-P 1131 - Manual (Page 24)

Using the Software
Control Panel Software Program
The printer allows you to select 42 initial setup items shown in the table below by using the Control Panel Software
program.
The printer has been factory set to operate with most of the popular software packages. If no changes are
required, you should be ready to print. In most cases there will be no need to change the initial setup items.
You can verify the current settings by pressing (F5] P. 26) after running the Control Panel Software program.
You can also verify the factory and current settings by turning the power on while pressing [PITCH] + [ ON LINE ].
Menu Item
PRINT STYLE FONT ‘I
PITCH
POINT SIZE ‘2
EMULATION EMULATION
PAGE FORMAT LINE/INCH
PAGE LENGTH
TOP MARGIN
BOTTOM MARGIN
LEFT MARGIN
RIGHT MARGIN
CTR PRINTHEAD
PRINT MODE GRAPHIC DIRECTION
TEXT DIRECTION
TEXT ENHANCEMENT BOLD
DOUBLE HIGH
DOUBLE STRIKE
DOUBLE WIDE
ITALICS
OUTLINE
SHADOW
ZERO FONT
Menu
CHARACTER SET
INSTALL
INTERFACE
T.O.F. (Top of Form)
SETTING
Item
CHARACTER SET
COUNTRY
CODE PAGE
AGM/IBM
AUTO CR/IBM
AUTO LF
AUTO LOADING
PAPER OUT DETECT
TEAR OFF
CSF MODE * *3
BUFFER CONTROL
AUTO ON LINE
AUTO FEED XT CONTROL
INTERFACE
DATA LENGTH
BAUD RATE *5
PARITY *5
PROTOCOL *5
TRACTOR
FRICTION
CUT SHEET FEEDER *3
-SC sequences are displayed only when one of the following CODE PAGE is selected: U.S.A., Multilingual,
Portugal, Canada French, Norway, Turkey.
displayed only when - SC sequences are selected in FONT.
*3 operational when using the optional Auto Cut Sheet Feeder (KX-PT12).
Download font function is disabled when ALL is selected.
*5 displayed when AUTO or SERIAL is selected in INTERFACE.
r Note:
* This program communicates between printer and computer. Before running this program under
I
Windows 3.1, Windows 95 or Windows 98, be sure printing is completed.
24