High speed mode, Turning on the high speed mode, Turning off the high speed mode – Panasonic KX-P 1131 User Manual
Page 29: Line feed / form feed (lf/ff), Using the control panel
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Control Panel
High Speed Mode
The High Speed mode is a feature for doubling the print speed only when LQ Font and one of the 120 dpi, 180 dpi
or 360 dpi of 24-pin bit image are selected.
Note:
• When enabled, this feature will lower the print density.
Turning on the High Speed mode:
While pressing (ON LINE), press [ LF/FF]
The HIGH SPEED indicator is on.
Turning off the High Speed mode:
While pressing (ON LINE), press[ LF/FF].
The HIGH SPEED indicator is off.
Line Feed / Form Feed (LF/FF)
You can adjust the paper position by using the front panel switches when the printer is in the OFF LINE mode or
when the printer is not printing in the ON LINE mode.
^
With paper installed, pressing [ LF/FF) once advances
the paper one line.
With paper installed, holding [ LF/FF) moves the
printhead to the center and advances the paper to the
top of the next page.
Note:
When pressing [ LF/FF
1
, the amount of paper which is fed is determined by the current setting for lines per
inch as specified through the Control Panel Software program, control panel (Initial Setup mode) or your
application software.
(O
(D
o
o
"0
0 )
3
(D
29