Panasonic KX-P 1131 - Manual (Page 30)

Using the Control Panel
Top of Form Function (TOF SET)
This printer has a Top of Form (TOF) function which stores the first print line position and loads the paper to the
designated position automatically. The first print line position will be stored even after the power is turned off.
You can adjust the Top of Form position through the Control Panel Software program (P. 24), or using Micro
Line Feed or Reverse Micro Line Feed ( below) from the Control Panel within 125 mm {5") from the top of your
paper.
Note:
• Do not rotate the platen knob, otherwise the printer wilt not be able to count the number of lines properly.
• All adjustments must be made on the first sheet. If you decide to change the setting and save it, remove the
paper from the tractors, then reset and reload the paper.
-f If necessary, redefine the page length of the paper you are using through the Control Panel Software
program (P. 24-26), Control Panel P. 32-33) or your application software.
(Micro Line Feed) (Reverse Micro Line Feed)
While pressing [ ON LINE], press
( TEAR OFF) .
This advances the paper one micro line
[0.14 mm (Vi8o")].
While pressing [ ON LINE], press
{TOAD/PARK] ■
This reverse the paper one micro line [0.14 mm
{Vl80")j.
The printer cannot reverse the paper past the
printable area (cS" P. 39 “Printing Area”).
3 At your desired position within 125 mm (5'") from the top of your paper, release the switches.
The paper position will be stored automatically as the new Top of Form position.
30