Advance sync output connectors (adv sync), Gpi input connector (gpi), Preview output connector (preview out, comp) – Panasonic WJ-MX30 User Manual
Page 13: Rs-232c control connector (rs-232c), Cooling fan, Main power switch (main power)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
90. Program Out-2 Y/C Output Connector
(PROGRAM OUT 2/Y/C)
The S-video Program Output Signal-2 is provided via
this connector.
91. Program Out-2 COMP. Output Connector
(PROGRAM OUT 2/COMP.)
The composite video Program Output Signal-2 is
provided via this connector.
92. Program Out-2 Audio Output Jacks
(PROGRAM OUT2 L/R)
The audio output signals of R-channel and L-channel
from Program Output 1 are supplied via these jacks.
93. Advance Sync Output Connectors (ADV SYNC)
In the A/B Roll Editing System, the Advance Sync signal
from this connector should be supplied to a playback
VTR which does not have a Time Base Corrector (T.B.C.)
inside.
Note:
Enough editing accuracy cannot be obtained
without this signal.
94. GPI Input Connector (GPI)
Refer to "INTERFACE” on page 28 for details.
95. Preview Output Connector (PREVIEW OUT, COMP)
The video effect of the composite video signal is
obtained at this connector regardless of which Program
Out Button is selected, (42) or (43).
96. RS-232C Control Connector (RS-232C)
Ask your the Panasonic Dealer for communication
software.
97. Cooling Fan
98. Main Power Switch (MAIN POWER)
The unit is in stand-by mode when this switch is
pressed on. Unless this switch is pressed on, the unit
will not be on even if the (front panel) Power On/Off
Button (1) is pressed.
11