Panasonic WJ-MX30 - Manual (Page 24)

D-5. Picture-in-Picture
Press the WIPE Button (51) to turn on.
Press the Picture-in-Picture Button (12). Move the
Wipe/Mix Lever (58) to the B-bus position from the
A-bus position. The following patterns can be selected
by pressing this button.
Double Picture-in-Picture mode
By using the Positioner Joystick (46), the position of
the picture-in-picture scene can be changed on the
monitor scene.
Notes :
• When pressing this button fourth times (Double
Picture-in-Picture mode), Matte Color cannot be
selected.
• In the Double Picture-in-Picture mode, the
picture quality is not same with it of single
Picture-in-Picture mode.
• In the Double Picture-in-Picture mode, position
control is available only up or down direction.
E. Basic Operation 4
E-1. Downstream Key
The following is a detailed description of the
Downstream Key block. This function is mainly used for
superimposing characters or letters for a telopper. The
optional Character Generator WJ-KB50 can be used
for this purpose.
Set the KEY LEVEL Control (33) to the end low position.
Select and press the FILL MATTE Button (37) for
a Key-Fill signal. The Key-Fill signal fills the key
signal. When the FILL MATTE Button (37) is pressed,
the desired color can be chosen from the MATTE
GENERATOR.
Press the EXT. CAMERA Button (40) for a Key Signal,
(or A-Button (35) or B-Button (36) can be selected)
Press the ON Button (34).
Adjust the KEY LEVEL Control (33) to obtain a clear
edge key image.
Example of using the title card option
In case a title is written on a black card, adjust the KEY
LEVEL Control (33) to obtain a clear edge key image.
Notes :
1. When the optional Character Generator WJ-KB50 is
used for a key source, set the KEY LEVEL Control (33)
to the low end position.
2. A jittery EXT. CAMERA signal or a jittery VTR playback
signal can cause a disturbance in synchronization.
22