Panasonic UF-333 - Manual (Page 65)

Receiving Documents
^
Setting the TAM Interface Mode
Change Fax Parameter No. 16 (OUT MODE) to 2: TAM l/F. (see page 33) 1
2
08-OCT-1999 15:00
RCV MODE=FAX/TAM 00%
Confirm that the lamp is ON and the dispiay is as shown
to the right.
Operation of TAM Interface Mode
1
When your TAM and Fax receives an incoming cail, the TAM aiways answers the call first
and then the TAM plays the OGM (Outgoing Message) recorded in your TAM to the calling
station. During the time the TAM is answering the call, your fax machine will be monitoring
the line to distinguish whether it is a voice or fax call.
If it is Fax call,
2a
Your machine will switch the line to the |
fax and then begin to receive the
I
documents immediately from the j
calling station.
|
If it is a Voice call,
2b Your TAM continues to record a
message (ICM) after playing the
OGM.
Sample of OGM
Hello, this is Smith. Sorry I am unable to take your call. Please leave your message after the
beep or if you are calling to send a fax, press the asterisk button twice on your touch tone
phone now and start your machine. Thank you for calling.
Silent Detection Mode
Enables your Fax machine to switch to the Fax Mode when receiving from units that do not
send fax signal (short beep) and prevents your TAM from recording blank (long silence)
incoming message.
To activate this feature,
1. Change Fax Parameter No. 20 (SILENT DET.) to 2 : Valid, (see page 34)
2. Set the time length of the OGM recorded in your TAM with the Fax Parameter No. 19
(OGM LENGTH), (see page 34)
[We recommend to set the time length to 5 or 6 seconds longer than the actual time length of the OGM.]
63