Panasonic NV-HD 630 - Manual (Page 34)

To Find the Beginning of Each
Recording
(VMS Index Search System)
Example:
Searching for the 2nd recorded segment in the forward
direction.
Press INDEX »i twice.
(This operation is performed while the VCR is in the stop
mode or normal playback mode.)
Display Symbol
r INDEX-1
• After finding the specific recorded segment, playback
starts automatically.
• If you press INDEX ►M too many times, simf^y press
INDEX to correct it. In this way, you can reduce the
displayed figure down to 1.
• Up to 20 index signals can be searched for in both
directions.
• The figure on the display decreases by 1 each time an
index signal is located.
Recording Index Signals
Index signals are recorded in the following cases.
• When a recording is started by pressing REC • (• REC/
OTR).
• When REC • on the remote controller is pressed during
recording.
• When timer recording is activated.
Note:
The index search function can only work correctly if the
index signals are spaced at least 5 minutes.
Searching while checking the
video cassette contents
(Intro-Jet Scan)
The approximate beginnings of each recorded programme
are played in succession at the high speed so that the
programme to be viewed can be located easily.
Preparations
• Confirm that the TV is on and the VCR viewing channel is
selected.
• Load the pre-recorded video cassette.
1 Press SEARCH.
(This operation is performed while the VCR is OFF or
while the VCR is in the stop mode or normal playback
mode with the VCR ON.)
On Screen Display
SEARCH
CD
•The tape is rewound to the start, and played for about
10 seconds at the high speed. It is then fast forwarded,
die VISS (VHS Index Search System) signals are
searched in succession, and each time the signals are
found, the tape is played for about 10 seconds at the
high speed.
When the programme to be viewed is reached, press >
(PUVY).
•Normal playback now commences.
To stop the operation at any time
Press □(STOP).
cn :o
Notes:
• This function may not work properly when recorded
programmes run for 15 minutes or less.
• When the timer recording is completed and the video
cassette is neither ejected nor replaced widi another one
and then SEARCH is pressed, the intro-jet scan function
will not work, and the programme list search function will
work instead. (See page 33.)
34