Phase dist, Symphonic dist, Distortion levei (distortion): 0 — 100 – Yamaha GEP50 User Manual
Page 16: Phase balance (phase bal): 0 — 100, Symphonic baiance (sympho bal): 0 — 100, Modulation frequency (mod. fro): 0.1 hz — 20 hz, Modulation depth (mod. depth): 0% — 100, Trigger levei (trg. level): 1 — 100, Release time (release): 5 — 32000 miiiiseconds, Moduiation frequency (mod. fro): 0.1 hz — 20 hz
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
23. Phase Dist.
24. Symphonic Dist.
Phasing plus distortion.
Symphonic plus distortion.
Distortion Levei (DiSTORTiON): 0 — 100%
Sets the “degree” or “depth” of the distortion portion of the
effect.
Distortion Levei (DiSTORTiON): 0 — 100%
Sets the “degree” or “depth" of the distortion portion of the
effect.
Phase Balance (PHASE BAL): 0 — 100%
Determines the amount of phase effect appiied to the distor
tion sound.
Symphonic Baiance (SYMPHO BAL): 0
—
100%
Determines the amount of symphonic effect appiied to the
distortion sound.
Modulation Frequency (MOD. FRO): 0.1 Hz
—
20 Hz
Sets the speed of the effect variation.
Modulation Depth (MOD. DEPTH): 0% — 100%
Sets the depth of the effect.
Modulation Deiay (MOD. DLY): 0.1 — 8.0 miiiiseconds
This sets the basic deiay time from the initiai direct sound to
the beginning of the phase effect.
Trigger Levei (TRG. LEVEL): 1 — 100
Determines the ampiitude of the input signai required to
trigger the effect. This parameter, in conjunction with the
RELEASE parameter beiow, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Release Time (RELEASE): 5 — 32000 miiiiseconds
Determines the amount of time it takes for the distortion
gate to close after the input signal drops below the trigger
level. Proper setting of the RELEASE parameter is essential
to allow a natural decay of the source instrument sound.
Moduiation Frequency (MOD. FRO): 0.1 Hz — 20 Hz
Sets the speed of the effect variation.
Modulation Depth (MOD. DEPTH): 0% — 100%
Sets the depth of the effect.
Trigger Levei (TRG. LEVEL): 1 — 100
Determines the amplitude of the input signal required to
trigger the effect. This parameter, in conjunction with the
RELEASE parameter below, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Release Time (RELEASE): 5 — 32000 miiiiseconds
Determines the amount of time it takes for the distortion
gate to close after the input signal drops below the trigger
level. Proper setting of the RELEASE parameter is essential
to allow a natural decay of the source instrument sound.
17
GEP50 GUITAR EFFECT PROCESSOR