Footswitch memory recall ranc, Footswitch memory recall range – Yamaha GEP50 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE: The program number/memory number assignments
made are stored in the BANK seiected in the previous
MIDI CONTROL function. To program the program
change/memory number assignments for a different ■
BANK, return to the MIDI CONTROL mode, select the
desired BANK, then program the required assignments.
/FOOTSWITCH MEMORY RECALL RANC^
The GEP50 permits memory selection via an optional YAMAHA
FC4 or FC5 footswitch connected to the rear-panel MEMORY
footswitch jack. The fourth function accessed by the UTILITY
button — F.SW MEMORY RCL — permits setting the range of
memory location numbers that will be selected when the
footswitch is pressed.
F . S W
MEMORY
RCL
RANGE
5 1 TO
7fl
If, for example, the RANGE parameter is set to “51 TO 70” as
shown in the LCD illustration above, each time the footswitch is
pressed the next highest memory location will be selected until
the last number in the specified range is reached. After the last
number in the specified range, the first (lowest) number is se
lected and the process repeated. Reverse sequences can be
programmed by entering the highest number in the range be
fore the lowest, as shown below.
F . S W
MEMORY
RCL
RANGE
5 4 TO
51
In this case the selection sequence is : 54
53
52 -> 51->
54, etc.
28