Yamaha YPDR601 - Manual (Page 13)

3 • Main unit (YPDR601) - Rear panel
(7) ERROR indicator
If a non-recoverable error occurs, this indicator will light. Press the Tr INC and
DISPLAY keys on the controller to determine the kind of error which has oc­
curred (explained in "Errors" on page 30).
3.2 Rear panel
The rear panel of the main unit is where audio and control connections are
made.
(p(|)
(3) (4) (D® (7)
ANALOS IN
@
— ANALOG OUT
I @ to?
©HIGH/LOW switch
This switch is used with the analog inputs, to allow the matching of the recorder
input circuitry with the analog source. The two positions correspond to:
Position Nominal level Maximum before clipping Impedance
HIGH +4dBm +24dBm lOkQ
LOW -9dBm +1 IdBm 50kQ
Both positions are adjustable ±3dB using the LEVEL ADJ (Lch, Rch) (2).
©LEVEL ADJ (Lch, Rch)
These two trimmer controls allow the fine adjustment of signal levels from the
analog inputs to the recording circuitry. The range is ±3dB from the center po­
sition (fully counter-clockwise gives -3dB, fully clockwise gives -i-3dB).
©ANALOG IN
These two XLR-type connectors allow the input of balanced analog signals at
levels determined by the HIGH/LOW switch (1) and LEVEL ADJ (Lch, Rch) (2).
YPDR
Main unit (YPDR50D-9