Panasonic SC-CH11 - Manual (Page 44)

To use the sleep timer
You can use this timer function to switch the power to the standby
mode at a desired time (within a range of 1 minute to 120 minutes
from the present time).
Use the steep timer to switch the power to the standby mode
automatically in case you fall asleep while listening.
(Step 6 also available from the remote control.)
Switch on the power.
1 Press CLOCK/TIMER while the sound source
is playing.
2 Turn the jog dial to select SLEEP while the
sound source is playing.
The display will return to the previous indication after 10 sec­
onds. Please finish setting within 10 seconds.
3 Press SET.
------------------------------------------------------- ^--------------------------------------------------
Cl C C p _ P ' H n -
MUiX'
J L
L
U t
C ’ U
u
^ 1 ^ UM
VOLUME
4 Turn the jog dial to set the length of time you
would like the system to operate before it
shuts off (sleep time).
(3^ ; 0:01-0:02-0:03-0:04...
^ : 2:00-1:59-1:58-1:57...
5 Press SET.
The display will return to the previous display.
The sleep timer indicator will appear.
illuminate
SLEEP
r Tl
I
rrn 1
MAX*
^-CB CB 1 U ‘ U
1
CDCEHICBCEtEnBnSQD
MM .
VOLUME
Above display shows the sleep timer setting on the CD player.
The sleep time set by the steps above remains in the system's
memory.
If you want to operate the system again on the same steep time, you
only need to press SLEEP.
■ To confirm the time remaining on the sleep
timer
(Also available from the remote control.)
Press SLEEP.
Approximately 5 seconds after you activate the sleep timer, the
display will return to show the mode display. If you press SLEEP in
this mode, the display will show the time remaining on the sleep
timer for approximately 5 seconds.
S L E E P 03G
51