Continued), Amplifier, Amplifier controls – Panasonic SC-CH11 User Manual
Page 9: Equalizer controls, Graphic equalizer level), 0 super bass button (super bass), 0 volume level control (volume), Volume preset button (vol preset), Remote control signal sensor (sensor), Input select buttons (tape, aux, cd, tuner)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Front Panel Controls and Functions
(continued)
Amplifier
■ Amplifier controls
0 Power “STANDBY c!)/ON” switch and indica
tor (POWER STANDBY (!)/ON)
This switch switches ON and OFF the secondary circuit power
only. The unit is in the "standby” condition when this switch is
set to the STANDBY (!) position. Regardless of the switch
setting, the primary circuit is always “live” as long as the
power cord is connected to an electrical outlet.
•The indicator will illuminate when the unit is in "STANDBY"
condition.
@ Equalizer controls
(GRAPHIC EQUALIZER LEVEL)
Use to adjust the equalization level.
These controls are for compensation of tonal quality. By sliding
the controls at each of the indicated frequencies in the
direction, the tonal quality is increased, and by sliding them in
t h e d i r e c t i o n , the tonal quality is decreased.
(See page 44.)
0
Super bass button (SUPER BASS)
Press to boost the dynamic low-frequency ranges.
0
Volume level control (VOLUME)
Turn to adjust the volume level.
When turning the control, the alphanumeric display shows the
volume level.
Note that — dB is the lowest volume setting and 0 dB is the
highest.
® Volume preset button (VOL PRESET)
Use to preset volume for timer piay.
(@ Remote control signal sensor (SENSOR)
Receives the signals from the remote control.
® Input select buttons (TAPE, AUX, CD, TUNER)
Press to select the sound source.
10