Panasonic NV-SD230A - Manual (Page 11)

How to Change the RF output Channel
(using the remote controller)
In some rare cases after tuning the TV' to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1 Hold down MENU for 5 seconds or more.
• The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
Display Symbol
How to Change the RF output Channel for New
Zealand
Operations
1 Hold down MENU for 5 seconds or more.
2 Press > (PLAY) to make ON appears on the VCR display.
• The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
Display Symbol
CO
Example
Example
Pimsonla vCn
PMiMOle veil
2 Enter the desired channel number (AU 28-69) by using
the numeric buttons or the s/ and buttons.
• Ensure that VCR/TV switch is set to VCR.
• Set the RF output channel of the VCR to “—” {RF
OFF) when the VCR is connected to the TV via the
AUDIO VIDEO cable.
Press the V and buttons to display “—".
3 Enter the desired channel number (21-69) by using the
numeric buttons or the V and buttons.
• Ensure that VCR/TV switch is set to VCR.
• Set the RF output channel of the VCR to"—’* (RF
OFF) when the VCR is connected to the TV via the
AUDIO VIDEO cable.
Press the v and buttons to display"—
28* 69^
(RF OFF)
21«------ »69^
(RF OFF)
/Ч
N/
Example:
28: © — ©-►©
3 Press MENU to finish the setting mode.
4 Retune your TV to the new RF channel for the VCR.
Note:
Even if the RF output channel has been changed, it is not
necessary to perform the TV station search.
N/
Example:
21: ©-*-©-►©
4 Press MENU to finish the setting mode.
5 Retune your TV to the new RF channel for the VCR.
Note:
Even if the RF output channel has been changed, it is not
necessary to perform the TV station search.