Panasonic NV-SD230A - Manual (Page 8)

Remote Controller Setup
Installing the Batteries
1 To remove the cover, slide it in the direction of the arrow
while pressing down.
If the Sliding Cover of the
Remote Controller becomes
Detached
If the sliding cover of remote controller becomes detached
by mistake, fit it securely in place by putting it on top of the
remote controller and pushing it down until It clicks into
position, as shown in the figure below.
® It is not possible to fit the sliding cover in place by pushing
it from the bottom end of the remote controller.
Do not attempt to do this.
2 Load the batteries with their polarity (© and ©) aligned
correctly.
Power Source for the Remote Controller
The remote controller is powered by 2 “AA”, “UM3” or
“R6” size batteries. The life of the batteries is about one
year, although this depends on the frequency of use.
Precautions for Battery Replacement
• Load the new batteries with their polarity {© and ©)
aligned correctly.
• Do not apply heat to the batteries, or an internal short
circuit may occur.
• If you do not intend to use the remote controller for a long
period of time, remove the batteries and store them in a
cool and dry place.
• Remove spent batteries immediately and dispose of them.
• Do not use an old and a new battery together, and never
use an alkaline battery with a manganese battery.
• Do not use rechargeable batteries.