Panasonic NV-HD675 - Manual (Page 19)

Preparations for G-Code Programming
Identification numbers must be set for G-Code
programming. Proceed with the G-Code programming
operation described on page 34, and the identification
numbers of the TV stations concerned wiil be set
automatically. This will allow G-Code programming to be
undertaken without performing the operation described
on this page. However, you can follow the setting procedure
described below if you wish to set the identification numbers
of all the TV stations prior to actual programming.
“Identification numbers" refer to the numbers used for
identifying TV stations.
The programme positions on the VCR receiving the TV
stations are set in these identification numbers.
Have a newspaper or magazine which iists today’s local TV
station programmes and G-Code numbers on hand.
Preparations
• Set the clock of the VCR. See page 18.
• Store TV broadcasts in your VCR. See pages 12-15.
• Confirm that the TV is on and the VCR viewing channel is
selected.
• Turn on the VCR.
POWER-.
■ VCR-..—TV; :■ IKfUTSaffiT:
/Ч
N/
ШЖ-
® CO , a
© ® ®
© © ©
® ® ©
® ® ©
oso-. -■ . 'иаклт" G.C0D£ ■
■RESET- rlNOEK-T.: ■ ■ - R E C '
О &:& m
CH ОАТЁ : Ш OFF
_ CANCEL SPEED I ____________
CD. : CD
310001 __ . VCP.TV
3 d) O
Operations
1
On Screen Display
Press MENU.
Sul
Г
:.,.C
»LANSUAGS
CLOCK SET
TUMGR PRESET
CH ADD&DELETE
O-COOECHSET
.rn.vsy,
OPTION
C’C
Select G-CODE CH SET.
CD
-t' K- (•?' t:- ^
Ш
LANGUAGS^
CLOCK SET
TUNER PRESET
CHADD&DELETE ^ q .CODECHSET
OPTION
йШ
3
Select the identification number (GUIDE
CH) (001-255).
CD CD
-л: iv i> ii) ft j.'
4
Press ◄ or ► then select the
programme position (1-99, A1 or A2).
I
CD
GUIDE CH CH
001 - -,i-
CD
•To set the other TV stations, press ◄ or ► then
repeat steps 3 and 4.
R’ <5 ^ Q 'V- '-.i i,: O •.-? i.'v v:- ■?, ‘i- (-V 0 i
Press MENU twice.
iiii
liis
vS C ii'; ’[r C 0 i;- ^ i,- :;v 0 ...
Note:
To receive satellite stations, the satellite receiver must be
connected to the VCR and programme position must be set
depending on the type of connection,
A1/A2: When the satellite receiver is connected to the
audio/video input sockets (AV1/AV2).
• When the satellite receiver is connected by means of the
RF coaxial cable, set to a free programme position
between 1 and 99.
qj
CO
]9