Panasonic CQ-FX85LEN - Manual (Page 34)

Speaker Connections
CAUTION;
1. Use ungrounded speakers only.
2. The speakers to be used with this unit should be able to handle more than SOW of audio power. If an
optional amplifier is used, the speakers should be able to handle the maximum output power of the
amplifier. Use of speakers with smali input ratings can cause damage to the speakers.
3. The speaker impedance should be 4 - 8 ohms. If the impedance is too large or too small, it affects the
output and may cause damage to the speakers or this unit.
4. Do not use 3-wire type speaker system having a common earth lead. Never connect the speaker cord
to the body of the car. This unit uses the BTCL circuit, so each speaker should be connected separate­
ly using parallel vinyl Insulated cords.
5. The speaker cords and the power amplifier unit should be kept away (about 30cm apart) from the
antenna and antenna extension cord.
6. Follow the connection diagram below carefully. Failure to do so may cause damage to both unit and
speakers.
• Unit will be damaged if speakers (Front, Rear) are not connected properiy.
RIGHT
White
L *
R*
White
w/Black Stripe.
Qrav
Gray
w/Black Stripe
WRONG
Chassis.^
rw
WRONG
Chassis
• Do not connect more than one speaker to one set of speaker leads.
RIGHT
White
White
w/Black Stripe
Gray ry^
Gray
w/Blaack Stripe
WRONG
L
L
R*
' ^
rr^
L
Kl
NOTE: Recommended external AMP combination (Example)
Preamp out (rear/front) CY-M9004 or CY-M7002
Sub-Woofer out “** CY-M9004
CQ-FX85LEN
41