Panasonic CQ-FX85LEN - Manual (Page 5)

H Power and Sound
H Controls
Power
If the car is not already running, turn the key in the ignition until the
accessory indicator lights.
Press PWR to switch on the power.
Press and hold PWR again to switch off the power.
Note: When power is switched on for the first time, demonstration display
appears. To release this display, press and hold PWR and switch power off.
Miss.
Volume
Press “VOL A” or" VVOL” to increase or decrease volume.
—Volume Level V / 1“ I .. I i n / j rr : ■ )~<
LJU.LJ.r'rt: . • TU --
0to40
Press “VOL A” or “VVOL” for more than a half second to sequential­
ly change numeric levels on the display.
3«DSB (3-Dimensional Surround and
Super Bass) and Loud Switching
CD
Press 3*DSB to switch on or off 3*DSB and Loud as follows.
3-DSB OFF
LOUD OFF
t______
3-DSB ON
LOUD OFF
3-DSB OFF
LOUD ON
____^
Press and hold 3*DSB for more than 2 seconds when 3»DSB is ON,
a degree of effect can be selected.
Press AVOL V to select one of the 10 degrees (0 through 9).
3«DSB System
it is a new sound system combining 3-dimensional sound from two
front speakers with rear channel super bass.
The 3«DSB employs Spatializer® ICs of Desper Products, Inc.
• When 3*DSB is turned on while receiving an AM monaural broad­
cast or when you are listening to an FM broadcast in monaural
mode, you will be able to listen to it with a virtual stereo effect from
4ch speakers.
Note; This unit is equipped with anti-volume-blast circuit which serves as an automatic volume level
adjuster so that you will not be deafened with sudden loud volume.
This system operates as below. When PWR is first pressed to switch on, the volume level is low. After
that, the volume level gradually returns to the level when the switch is turned off.
Anti-volume-biast circuit is not effective when volume level is lower than position 20 at the display.
12
CQ-FX85LEN