Panasonic OMNIVISION PV-8661 - Manual (Page 18)

Timer Recording
important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program while you are
away or otherwise occupied. Up to 8
programs can be stored in memory.
[^^Check list before you begin.
Q All connections are made.
(See pages 6-9.)
O TV and VCR are plugged in and turned on.
Q VCR/TV selector is set to “VCR.”
□ Clock is set to correct time.
□ Record tab in place. (See page 5.)
1
5
6
1
Press PROG* to display the
“SET PROGRAM” screen.
2
Press
AT to select “TIMER
PROGRAM,” and then press ►
to display the program screen.
• If a program is already in memory, press AT
and ► to select an unused program number.
---------- SET PROGRAM ---------------
VCR Pli«+ PROGRAM
SELECT;* ▼ KEY
SET :► KEY
END iPROG KEY
START STOP CH
CATEGORY :NM
BiiasBHiaEEiB
SELECT:* ▼ KEY
SET
KEY
END :PROG KEY
3
Press
AT
and
►
to select and
set one of the following;
• 1-31 =Onetime recording
• DAILY =Same time MON~FRt
• WEEKLY (SUN-SAT) =Same time once a week
Example 9....... 31 1 2' 6
Today’s Date 7 SELECT A / T Selection Order DAILY
L^WEEKLY......... WEEKLY____WEEKLY_J
(SAT) (MON) (SUN)
Press
AT
and
to select and set each
of the remaining
items at right.
4
Press
AT
and ◄ ► ."“ir!
• CH(annel) number, or LINE
for outside source recording
• Category (N/A [not applicable],
SPORTS, MOVIE, COMEDY,
MUSIC, DRAMA)
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► to move the cursor to the right, or ^ to
move to the left to the incorrect entry and make the correction.
5
Press PROG to end the program.
• This screen appears for confirmation.
To Enter More Programs
Press
AT
and ► to select and set a blank
program number, and then repeat stepra 3 and 4.
Press PROG to exit this mode.
Press POWER off to set the timer.
• When recording programs via a cable
box, make sure the cable box is left
ON and tuned to the desired channel.
P DT START STOP CH SPD
lliTA'MgATJIfegiTtfiT‘
2 -- --
3 -------:-------
4 ----------- --
CANCEL:ADD/DLT KEY
SELECT 1-0:* ▼ KEY
ENTER ;► KEY
END ;PROG KEY
-DE12-
Multi Function Display
Important notes when using a DSS receiver
• When recording programs via a DSS receiver, the DSS receiver must be left on.
• When recording programs via an antenna or cable, the DSS receiver must be turned off.
18
A cassette with no record tab is ejected and “TIMER” flashes when the power is turned off to set the timer.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a norma! recording or One Touch Recording (page 17),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording will not be performed or continue.