Panasonic OMNIVISION PV-8661 - Manual (Page 29)

^Important: If the remote control POWER, ACTION, PROG, CHA/V, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again,
If you are using a cable box and it is connected to your VCR in one of the ways shown in Connection Type A
on page 28, you will need to complete the Cable Box Setup steps below.
1
6
2
3
4
5
Cable Box Setup
Complete this page only if Type A
connection method (pg.28) is used.
1
Press ACTION* to display
the menu.
Press AT to select “SET UP
CHANNEL,” and then press
► to display the “SET UP
CHANNEL” screen.
MENU
SET UP VCR
SET UP FEATURE
тЮМА/ LANGUE: ENGL I SH
SELECT:* ▼ KEY
SET
:► KEY . '
END : ACT ION KEY
Press
AT
to select “CABLE/
DSS BOX SETUP," and
then press ► to display the
“SELECT HOOKUP” screen.
------- SET UP CHANNEL
ANTENNA ; CABLE
AUTO SET
CHANNEL CAPTION
VCR R ls + CH set up
SELECT:* ▼ KEY
SET
KEY
END lACTION KEY
Press AT to select your hookup,
and then press to set.
• If you selected CABLE/DSS BOX^
VCR^TV, continue with step 5.
If not, press ACTION three times
and turn to page 30.
VCR>CABLE/DSS BOX^TV
VCR^TV
SELECT;* ▼ KEY
SET ;► KEY
END lACTION KEY
Press
AT
to select your cable
box or DSS receiver output
channel number, and then
press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using AudioA/ideo jack
connections to your cable box,
select and set “VIDEO OUT as
the output channel.
SELECT HOOKUP
CABLE/DSS 80X>VCR>TV
CABLE/DSS BOX OLfTPUT CH 1M!MI
SELECT:* ▼ KEY
SET
:•* ► KEY
END lACTtON KEY
6 Press ACTION twice to end the setup and return
to the normal screen.
Go directly to “VCR Plus+ Programming” on page 31.
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar
Development Corporation.
29