Automatic search, Manual search, Tuning procedure – Panasonic TC-21SV10M EN User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
( Tuning Procedure^
Automatic Search
(Country System must already be set)
Manual Search
(Country System must already be set)
1. Press the ’’PRE. (PRESET)" button twice.
The on-screen display appear as shown*.
1. Press the "PRE. (PRESET)" button three times.
The on-screen display appear as shown;
1
CH4
SYS SELECT
AUTO TUNg~1
MANUAL TUNE
SOUND SYS
COLOUR SYS
FINE TUNE
SKIP
PRESET
CHINA
6.5MHz
AUTO
OFF
2. Press the Volume Up or Down button on the TV set.
The best tuning position is automatically memorized.
3. After all stations are tuned, the on-screen display will
automatically change from "AUTO TUNE” to "SOUND SYS".
Confirm the sound condition of each Programme Number by
pressing the Programme Number Up button.
4. If the Sound is not clear or no sound is produced on a
Programme Number, press the Volume Up or Down
button to improve the Sound quality.
You can select one of the sound system as below;
, MODEL ■' : ,. ■
SOUND SYSTEM
TC-14SV10H
TC-21SV10H
6.0 MHz 6.5 MHz
TC-14SV10S
TC-21SV10S
5.5 MHz ^ 6.5 MHz
TC-14SV10M
TC-21SV10M
5.5 MHz
1
CH4
SYS SELECT
AUTO TUNE
.MANUAL TUNE
1
.SOUND SYR I
COLOUR SYS
FINE TUNE
SKIP
PRESET
CHINA
6.5MHz<
AUTO
OFF
blinking
5. Use the Programme Number Up button to sequentially check
each station.
6. After completed, press the "PRE. (PRESET)" button 4 times
to return the set to the normal viewing condition.
1
CH4
SYS SELECT
AUTO TUNE
1 M
a
NO
al
SOUND S
y
S
COLOUR SYS
FINE TUNE
SKIP
PRESET
CHINA
6.5MHz
AUTO
OFF
2. Select the desired Programme Number.
3. Press the Volume Up ”+" or Down button, the TV station
broadcasting on the next higher or lower frequency will be
automatically tuned and memorized.
If an undesired TV stations is received, press the same
button again until the desired TV station is tuned.
You can also select a specific programme number by
pressing the desired programme number after pressing
the "C" (Channel) button. (Refer to page 7 )
4. Press the "PRE. (PRESET)" button.
5. Select the Sound system by pressing the Programme Number
Up button.
If the Sound is not clear or no sound is produced on a
Programme Number, press the Volume Up 'V" or Down
button to improve the Sound quality.
6. After completed, press the "PRE. (PRESET)" button 4 times
to return the set to the normal viewing condition.
11