360 Systems Instant Replay DR-554 - Manual (Page 46)

Page 46 Instant Replay Owner's Manual
After pressing E NTER or C ANCEL the display briefly shows the number of files transferred without
error:
FILES SENT: 0
PLEASE WAIT
If any files could not be sent, the display shows the number of files transferred without errors and the
number of files not sent due to errors:
FILES SENT: 0
FILES NOT SENT: 1
Note that Errors shown in the Transmitter are never the result of cabling or interface problems; they
reflect a problem within the unit. Transmitter errors will also be shown on the Receiver, but Receiver
errors are shown on the Receiver only.
File Transfer (RECEIVER)
When Instant Replay is idle and FILE RECEIVE is ON, it monitors the selected RECEIVER INPUT
(XLR-3 or RCA) for a file transfer with destination name that matches the stored receiver name.
When a file transfer addressed to the Receiver begins, the display shows the following:
FILE 1 OF XX
00% COMPLETED
•
If Cancel or Stop is pressed, the transfer proceeds while the following prompt is
displayed:
QUIT TRANSFER?
PRESS ENTER/CANCEL
•
Press Cancel for the transfer to proceed.
OR
•
Press Enter to exit from the transfer. The display will show:
TRANSFER INCOMPLETE
PRESS ENTER/CANCEL
When a transfer is completed without errors, the following message appears:
TRANSFER COMPLETE
NO ERRORS
If files were received with errors, the display then shows the number of files received without errors
and the number of files discarded due to errors:
GOOD FILES: XX
BAD FILES : 0
•
Press E NTER or C ANCEL . The display will briefly show:
FILES SENT: X
PLEASE WAIT
The display then shows the number of files received without errors and the number of files discarded
due to errors: