360 Systems Instant Replay DR-554 - Manual (Page 49)

Instant Replay Owner's Manual Page 49
CHAPTER FIVE – Maintenance and Disk
Operations
FORMAT INTERNAL HARD DISK
The Format Disk option for the internal drive is only available through a special "power-on"
sequence. This option will erase the entire contents of Instant Replay's internal hard disk It is
essential to back up the contents of your hard drive using the D-NET File Transfer or Backup/Restore
procedures detailed in Chapter 4 “D-NET File Transfer Operations” before beginning the Format Disk
operation.
During FORMAT DISK, if you wait too long to select an option, Instant Replay will "time out",
aborting the Format Disk operation.
CAUTION!
FORMAT DISK WILL PERMANENTLY ERASE THE CONTENTS OF THE HARD DISK .
IF AT ANY TIME THE FORMATTING PROCESS IS ABORTED, YOU MUST RECYCLE POWER
(TURN THE MACHINE OFF, THEN BACK ON AGAIN) TO ENSURE PROPER OPERATION. REPEAT
THE FORMAT PROCESS AFTER CYCLING POWER.
To Format the Internal Hard Disk
•
Turn Instant Replay's power switch OFF.
•
While holding down the S TOP button, turn power ON. Continue to hold stop until the unit
initializes. The display will prompt:
FORMAT & ERASE DISK?
PRESS ENTER/CANCEL
•
Press E NTER to proceed, or C ANCEL to abort. If you press E NTER , the display will prompt:
PLAY
CANCEL
•
Press P LAY to continue. The display will prompt:
FORMATTING
WAIT
After the formatting operation is complete, the display will show the initializing message, then will
indicate “NO CUTS AVAILABLE”. At this point, you may:
•
Press R ECORD and begin recording new material.
OR
•
Press M ENU , select the FILE TRANSFER Menu, then select RESTORE FROM BACKUP.
Audio material previously backed up to DAT may now be restored to the hard drive via the
AES/EBU input.
OR
•
Restore recordings from Zip disk backups.