Acoustica Spin it Again - Manual (Page 13)

Getting A Good Recording Level
Click the "Level Wizard..." button to launch the Level Wizard.
The Recording Level Wizard helps you get the best recordings.
Step 1: Choose the right sound card and source
If you have more than one sound device, make sure to choose the one that your record player
or cassette player is plugged into. The software will automatically attempt to choose the "Line
In" or equivalent. However, all sound devices are different and you may need to manually
select the correct source. (If it's a USB device, make sure that it is connected.)
Step 3: Check "Monitor" if necessary
If you have a USB sound device and you'd like to be able to hear the recording through your
speakers, click the "Monitor" checkbox.
Step 3: Start the Wizard
Click "Start". Make sure to play back the loudest part of the loudest song. It will automatically
lower the recording level until it is optimal. In addition, it may have you turn down the input
level from the tape or record player.
(IMPORTANT: You may have to lower the volume on your stereo amp if the signal is coming
in too loud. Spin It Again will some times be able to detect distortion, but not always.)
Get A Strong Recording Level
Later on, after your recording is done, make sure you don't have a weak recording. If your
recording looks like a weak recording, you may still need to adjust a volume or input to get a
stronger recording level.
Example of a weak recording level:
Page 13 of 39 Spin It Again
7/10/2007 file://C:\acoustica\vinylman\help\flat\spinitagain.htm