Acoustica Spin it Again - Manual (Page 18)

whatever you'd like. Just choose either one of the recording buttons to record from a source
other than LP or tape.
Recording Screen
Step 1: Make sure you are ready to record!
If you haven't hooked up your cassette or record player to your computer, run the "Hardware
Hookup Wizard"
If you haven't adjusted your recording level, run the "Level Wizard"
Step 2: Adjust "Auto Pause" if necessary.
The software will automatically pause recording after a certain amount of time. If you are
going to be gone for any amount of time, this allows you to set the maximum time it will
record. Otherwise, it would fill up your hard drive with hours of silence.
Choose an auto pause time which is a little longer than the music you are going to record. For
cassette tapes, make sure you rewind it first!
Step 3: Start recording
Click the "Record" button and then start playing the record or press play on the tape deck.
Step 4: Type or look up album information during recording
While the software is recording, click "Type or Look Up Album Info..." button and enter in the
album and track information. On this pop up window, you can also click a button that lets you
type in the album or artist name and automatically get the track and album information so you
don't have to type it! (The track times and number of tracks can help in track detection,
especially if the album has continuous audio such as a live or concert recording.)
Step 5: Record the other side of the tape or record
The software will automatically pause when it senses the end of the record. Flip the record or
tape over and play side two.
If the software auto-paused, click "Record" before playing side two.
Page 18 of 39 Spin It Again
7/10/2007 file://C:\acoustica\vinylman\help\flat\spinitagain.htm