ALFA NETWORK TUBE-U(N) - Manual (Page 33)

January 13, 2009 / Version: 2.0 29
7. Configure one or more credentials. Then connect successfully.
8. Click "Detail." You can see the figure below.
C. Example of Adding to the Registrar Using the PBC Method
The PBC method requires the user to press a PBC button on both the Enrollee and the Registrar
within a two-minute interval called the Walk Time. If there is only one Registrar in PBC mode, the
PBC mode selected is obtained from ID 0x0004, and is found after a complete scan. The Enrollee
can then immediately begin running the Registration Protocol.
If the Enrollee discovers more than one Registrar in PBC mode, it MUST abort its connection
attempt at this scan and continue searching until the two-minute timeout.
Note: Before you press PBC on STA and candidate AP. Make sure all APs aren't PBC mode or APs
using PBC mode have left their Walk Time. The user can configure WPS profiles with either PIN
method or PBC method.
Please follow the steps below.