ALFA NETWORK AIP-W411 - Manual (Page 10)

AIP-W411 150M Wireless 11N Router
- 4 -
The Router’s LEDs and the WPS/Reset Button are located on the front panel (View from left to
right).
Name Status Indication
PWR
Off Power is off.
On Power is on.
SYS
On The Router is initializing.
Flashing The Router is working properly.
Off The Router has a system error.
WLAN
Off The Wireless function is disabled.
Flashing The Wireless function is enabled.
WAN,
1,2,3,4 (LAN)
Off There is no device linked to the corresponding port.
On
There is a device linked to the corresponding port but
there is no activity.
Flashing There is an active device linked to the corresponding port.
WPS
Slow Flash
A wireless device is connecting to the network by WPS
function. This process will last for about 2 minutes.
On
A wireless device has been successfully added to the
network by WPS function. The LED will keep on for about
5 minutes.
Quick Flash
A wireless device failed to be added to the network by
WPS function.
Table 1-1 The LEDs Description

Note:
1. After a device is successfully added to the network by WPS function, the WPS LED will keep
on for about 5 minutes and then turn off.
2. When press and hold the WPS/Reset Button for more than 5 seconds, you will reset the
router.
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).