Analogue Solutions Telemark /-K - Manual (Page 19)

A
analogue Solution – Telemark – 2014 19 | P a g e
No Signal?
Check the following…
 Your mixing desk / monitoring equipment is on and working correctly.
 Check the synth is switched on and that the power adaptor is functioning correctly.
 Check it is connected to your monitoring equipment correctly and that the cable is not faulty.
 Ensure the output volume is high enough.
 Ensure the mixer level controls are turned to some sound source like the VCOs or Noise.
 Certain extreme filter settings may filter out all of the signal or produce low level signals. Try adjusting the
filter cut-off.
 Certain extreme PW/PWM settings may cause the pulse outputs to cut-out. Try adjusting PW/PWM as
necessary.
 Try putting the VCA to ON to hear the raw sound, but if you are using a MIDI keyboard to trigger the
envelopes and VCA, ensure correct MIDI connection, and that the correct channels have been selected.
Quick method for zero modulation
Some of the modulation level controls are zeroed when in the centre position. It is quite easy to zero these controls to
have no modulation. But another quick and sure method to obtain this is the put the modulation source switch to
either EXT1 or EXT2. Assuming you have no signals coming into these rear panel sockets, you will eliminate any
modulation.
Expansion
For the DIY enthusiast and those wishing to invalidate their warranty, most of the signal source and destination points are
indicated on the circuit board. It would be possible with some good skills to bring these points to front panel sockets.
Of course we do not recommend you do this and it will invalidate all warranties.