Safety instructions – Analogue Solutions Telemark /-K User Manual
Page 4
A
analogue Solution – Telemark – 2014
4 |
P a g e
Safety Instructions
Please read carefully before using:
Only use the correct power adaptor - 230V (or 115V whatever your country needs)
Never handle the adaptor with wet hands
Never excessively bend the adaptor cable or get it trapped or place heavy objects on it. If the
adaptor cable becomes damaged, replace the adaptor.
Ensure the unit is disconnected from the mains before moving or cleaning.
Always disconnect the unit from the mains if there is lightning in your area.
Ensure the unit is on a stable surface, and never place heavy objects on top of it.
Never allow young children or animals to operate the unit or adaptor.
Do not use excessive force when using the controls or inserting cables to the connectors.
The unit should not be operated in the rain or near water and should not be exposed to moisture.
If the unit is brought from a cold environment to a warm one, the unit should be left to reach the
ambient temperature.
Keep away from heat sources, such as radiators, ovens, heaters etc.
Never allow it to get wet. Do not operate it near water, like pools, sinks, bathrooms etc.
Do not place beverages on or near it.
Never open the case or attempt to make repairs. Refer any servicing to qualified service personnel.
Preventing damage to other connected devices;
Telemark has a very high dynamic range. It is capable of produce loud signals of very high and sub-sonic
frequencies that could blow inadequate speakers if played too loud. It is recommended that input levels to
external equipment (mixers, amp's etc.) are kept low when first connected, and then slowly increased to a
useable level.
Maintenance Instructions
Any cleaning of the Telemark case should be done with a clean lint-free cloth. DO
NOT USE SOLVENTS OR CLEANERS, as this will deteriorate the exterior appearance of the
equipment.
Mounting
Mounting does not mean 'place on the wall' or 'to make love to' in this instance. Place
Telemark soundly on any stable surface so he cannot fall off or over, causing it or yourself injury.
POWER
The unit needs a 12 to 15V AC supply, minimum 500mA. DC Power supplies will not work