Aviom AV-P2 - Manual (Page 20)

12 Av-P2 O
utPut
M
Odule
u
ser
G
uide
Mounting the AV-P2
The AV‑P2 module is designed to be mounted to any flat surface. Optionally,
it can be rack mounted using a standard 19‑inch rack shelf. Two AV‑P2 units
can fit on a single rack shelf.
The mounting flanges on each side of the device are designed to support
the weight of the AV‑P2 without additional hardware. The mounting flanges
can be reversed easily using only a Phillips head screwdriver. Each mounting
flange contains holes for two screws per side. Always support the unit with
all four screws when attaching the product to a flat surface.
If desired, the mounting flanges can be turned around so that they mount
under the AV‑P2, making the profile of the AV‑P2 as small as possible. Always
use all the mounting screws when reversing the flanges on the AV‑P2.
Always allow adequate ventilation for devices mounted in equipment racks.
Avoid placing your AV‑P2 directly above or below other rack‑mounted
devices that produce high levels of heat, such as power amps.