ChemoMetec SCC-100 - Manual (Page 15)

1 Installation
5
For the installation of SomaticView insert the NucleoCounter SCC-100 CD-ROM into the
computer. To start the installation, locate the file “SETUP.EXE” on the CD-ROM and open
it (double-click it using the mouse). The dialogue shown in figure 6 will appear. Click
“Finish” to complete the installation.
Figure Figure Figure Figure 6 66 6 Dialogue box for installation of SomaticView.
When the installation is finished the computer will display a dialogue saying
“SomaticView installation successful!” Click “OK” and proceed with the installation of
the LabVIEW application as described below.
SomaticView is written in the LabVIEW system. Therefore it is necessary to install a
LabVIEW application on the hard disk. When SomaticView has been installed, the
installation of a LabVIEW application is automatically activated and a dialogue is shown,
see Figure 7. Please click “Next” to continue.
Figure Figure Figure Figure 7 77 7 Start-up dialogue for installation of the LabVIEW application