Removal of the somaticview software, Removal of the usb driver – windows 2000, Emoval of the – ChemoMetec SCC-100 User Manual
Page 17: Omatic, Iew software
1 Installation
7
If the installation is successful the dialogue shown in figure 10 will appear. Click
“Finish” to complete the installation. The SomaticView software and LabVIEW application
are now installed.
Figure
Figure
Figure
Figure 10
10
10
10 Successful installation of the LabView application.
For directions on start-up and use of the SomaticView software please refer to chapter 2
Getting started with SomaticView
on page 11.
1.3
Removal of the SomaticView software
For removal of the SomaticView software and the USB device driver follow the
directions below.
1.3.1 Removal of the USB driver – Windows 2000
In order to remove the USB device driver make sure that the NucleoCounter SCC-100 is
turned On and connected to the computer using the USB cable. Then locate the “My
Computer” icon on the desktop and option-click on the icon (click once using the right
mouse button). Click on “Properties” and the “System Properties” dialogue will appear.
Alternatively open the "System" module of the Control Panel.