COP-USA CD59NV-IRWP - Manual (Page 21)

IR Speed Dome Operating Manual
20
2) SENSITIVIRY:
Here the user can
manually set the
sensitivity from 1‐5.
The
smaller the
number is, the lower light of the environment will be when the IR LED on.
3) IR LED POWER: Here the use can choose the power mode covering: NORMAL, MATCH and USER.
NORMAL: Near IR LED will be turned on when wide angle. and Far IR LED will be turned on when
small angle.
MATCH: The Near and Far IR LED will be turned on and off automatically to match the zoom in and
out.
USER: The user can manually adjust the Near and Far IR LED.
4) AUTO CONTROL:When it is on, the IR LED will turn its power consumption to the standby status
which will effectively extend the service life of IR LEDs. And under this mode, when objects appear
in the screen, the IR LED will turn its power consumption back to the normal status.
5) STANDBY POWER: When the AUTO CONTROL is on, the user can set up the standby power here.
6) STANDBY DELAY: Set up how long if there is not moving object, the IR LED will turn into standby
status.
7) SENSITIVITY: When the AUTO CONTROL is on, the user can set up the sensitivity to detect the
moving objects.
8) ENHANCED MODE: Under normal status, press IRIS OPEN to enhance the IR LED power, when it is
turned to maximum, press IRIS OPEN continuously for 2 seconds to enter the enhanced mode. And
the whole brightness of the image will be improved. Move the cursor to EHNANCED MODE and
press IRIS to enter and select between” STATIC” and “DYNAMIC”
9) START/STOP TIME: Set up time for IR LED to open and close under “TIMING” of control mode.
•WIPER
The user can make adjustment for the wiper under
this menu (suitable for wiper‐equipped dome)
1) Numbers : Move the cursor to “NUMBER” and press IRIS OPEN
to enter the setup of Wiper Number. Move the joystick up and
down to select number (1‐10),then press IRIS OPEN to confirm.
2) Speed: Move the cursor to “SPEED” and IRIS OPEN to enter the
setup of Wiper speed. Move the joystick up and down to select
“HIGH” ,“MID ”OR “ LOW”, the press IRIS OPEN to confirm.
3) Start : Move the cursor and press IRIS OPEN to start wiper.
TIMING LED will be adjusted according to Open and Close Time.
OPEN IR LED forcedly open
CLOSE IR LED forcedly close
CAMERA IR LED status (Open/Close) will be synchronized with Camera
day and night switching
MAIN MENU
LANGUAGE :ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
<CAMERA>
<MOTION>
RESTART
FACTORY DEFAULTS
HELP
EXIT
DOME SETTINGS
<IR LED>
<WIPER>
<IDLE>
<ALARM>
<PRIVACY MASK>
<CLOCK>