COP-USA CD55HD - Manual (Page 20)

Operation Manual for Intelligent Speed Dome Camera
19
Precision 0.1°
Control mode RS485
Baud Rate 2400/4800/9600/19200 bps
Fan & heater Fan & heater auto-start (only outdoor dome)
Environment temp
Indoor dome-5 — +45
Outdoor dome –35 -- +55
2 Camera Optional data table
Effective picture elements Approx.2,000,000 pixels
HD:1080i/59.94, 1080i/50,720p/59.94,720p/50
Video signal
SD:NTSC(CROP),NTSC(SQUEEZE),PAL(CROP),PAL(SQUEEZE)
10X zoom(F1.8 to F2.1)
Lens
F=5.1mm(WIDE) to 51mm(TELE)
Digital zoom 12X(120X with optical zoom)
Angle of view(H) Approx.50 degree(WIDE end) to Approx.5.4 degree(TELE end)
Min illumination 1.0 Lux ICR On(F1.8) with 50 IRE
S/N ratio 50 dB or more
Iris Auto/Manu
Focus Auto/Manu
B.L compensation ON/OFF
White balance AUTO/INDOOR/OUTDOOR/ONE PUSH/MANU
Gain Control Auto/Manu
Exposure compensation 10.5dB
HD: ANALOG COMPONENT(Y/Pb/Pr)
Video output
SD:VBS
. Troubleshooting
Problem Probable cause Solution
Power supply fault Replace
Bad connection of the power Make correction On power no action
Transformer damaged Replace
Mechanical failure Repair
Camera incline Reinstall
On power cannot self-check
have image but have motor
noise
Power supply not enough Replace
Video signal fault Reinstall
Bad connection of the video Press to full connect
Self-check ok, but have no
image
Camera damaged Replace
RS485 Bus bad connection Check the RS485 connection
Dome id setting is wrong Reselect
Self-check ok but cannot
control
Protocol setting is wrong Reset and on power again
Bad connection of the video Press to full connect
Vague image
Power supply not enough Replace
Self check error On power again
Bad connection of control Press to full connect On power cannot control
Bad control of matrix On power again
Appendix : Lightning Proof and Surge Signal Proof