COP-USA DVR2716XD-M User Manual

Page 35

Advertising
background image

DVR User Manual

30

Step3: The setup steps of motion trigger are similar to „Alarm Handling‟. You can
refer to Chapter 4.5.1 Sensor Alarm Handling for more details.
Step4: Click “Setting” button under the Area to display the following picture as
shown in Fig 4-22:
Step5: In the Area tab, you can drag slide bar to set the sensitivity value (1-8). The
higher the value is the more sensitive it is to motion. Since the sensitivity is
influenced by color and time (day or night), you can adjust its value according to
the practical conditions. Left click the grid and drag to delete area. Drag again to

add area. Click

icon to set the whole area as detection area. Click

icon to

clear the set detection area. Click

icon to test the sensitivity as per the local

conditions. Once motion is sensed, it displays a figure icon. Click

icon to

save the setting. Click

icon to exit the current interface. Fig 4-22 Motion-Area

Note: Prior to setting motion detection field it is recommended that you click

icon to clear the existing field and set afresh.

Step6: Select “All” to setup all channels with the same parameters.
Step7: Click “Apply” button to save the setting.
Step 8: Enter into Schedule tab. The setup steps for schedule for motion based
alarm are similar to normal schedule setup; you can refer to 4.4.1 Schedule for
details. This step is very important for motion based alarm. Even if you have
enabled the motion based alarm for all channels and setup the trigger, you will
not see the result of motion based alarm if no schedule is added.
If you have set the schedule for senor based recording in the same timeline,
recordings can also be triggered.

Fig 4-23 Motion-Schedule

Advertising