ClearOne comm ClearOne RAV 900 - Manual (Page 35)

Web Interface — Overview 65
Dial
You can make all your calls from the Dialer in the web interface. You can dial a number,
redial the last dialed call and disconnect calls. You can also use flash settings, mute the
microphones and adjust volume.
To open the dialer window
• Click the Dial button in the left channel navigation.
To make a call
1. Click the ON/OFF button to take the phone off-hook.
2. Using the number pad, dial a phone number just as you would on a standard phone.
Note: You can also pre-dial the number and press the ON/OFF button to connect the call.
Tip: You can also dial using the 0-9, star (*) and number (#) on your on your keyboard. Use
the comma (,) key to enter a two second pause.The Enter key connects to and disconnects from
the telephone line.
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Web Interface — Overview 64
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Accessing the web interface
The RAV has a built-in web server that provides a remote access interface to your RAV system.
However, not all programming and metering functions are available.The web interface allows you
to connect to a RAV unit, run system checks, view the event log and manage calls.
To use the web interface from outside your network, your firewall must be properly configured to
allow access. If you are accessing RAV from within the network, you may use the network name.
The web interface uses Port 80.
To connect to RAV through the web
interface
1. Open a web browser and enter the IP
address or Network Name of the RAV in the
address bar.
2. Enter your User Name and Password . The
default user name is ClearOne and the
default password is RAV .
The RAV web interface opens. Navigation
buttons are shown in the left channel.
Overview
Figure 5.1. Network Password
Figure 5.2. RAV-Ware management system
Figure 5.3. Dialer window
/