Cub Cadet T65 Series User Manual
Page 103
Crankshaft, piston and connecting rod
97
11.
Install the fuel tank by following the steps described in Chapter 4: Fuel systems and Governor.
12.
Install the carburetor by following the steps described in Chapter 3: Air Intake and Filters.
13.
Install the flywheel and module by following the steps described in Chapter 7: Ignition system.
NOTE: If equipped, install the engine brake by following the steps described in the application’s service man-
ual.
14.
Install the blower housing and starter by following the steps described in Chapter 6: Starter.
15.
Install the engine on the application by following the steps described in the application’s service manual.
16.
Install the spark plug by following the steps described in Chapter 7: Ignition system.
17.
Fill the engine with oil and fuel by following the steps described in Chapter 1: Introduction.
18.
Test run the engine in a safe area and make any carburetor and governor adjustments needed.