Cub Cadet T65 Series - Manual (Page 39)

A IR I NTAKE S YSTEM
33
Carburetor Insulator
To remove/replace the carburetor insulator:
1. Remove the air filter housing by following the previ-
ously described steps.
2. Remove the carburetor.
2a. Clamp off the fuel line.
2b. Disconnect the fuel line from the carburetor.
2c. Drain the fuel tank in to an approved container.
2d. Remove and discard the fuel line. See Figure
3.6.
NOTE: Disconnecting the fuel line causes tiny tears in the
inner lining of the fuel line. These tears will col-
lapse the inner lining, cutting off fuel flow.
NOTE: If the engine is not equipped with an autochoke,
skip ahead to step 2l.
2e. Remove the recoil starter by following the pro-
cedures described in Chapter 6: Starters
2f. Lift the blower housing off of the engine.
2g. Remove the tin gasket. See Figure 3.7.
2h. Remove the Autochoke Linkage Bracket.
2i. Remove the carburetor gasket.
To avoid personal injury or property damage, use extreme care in handling gasoline. Gaso-
line is extremely flammable and the vapors are explosive. Serious personal injury can occur
when gasoline is spilled on yourself and/or your clothes which can ignite. Wash your skin
and change clothes immediately
! WARNING ! WARNING
Figure 3.6
Figure 3.7
Tin gasket
Autochoke Linkage Bracket