Cub Cadet T65 Series - Manual (Page 72)

T65 Series Vertical Shaft Engines
66
NOTE: The rolled end of the pawl fits in the recess
in the starter pulley. The hooked end
engages the starter cup. Both the roll and
the hook face inward.
NOTE: The extrusions on the pressure plate should
fall inside of the pawls as the starter is
assembled.
NOTE: Drag on the pressure plate, from the friction
between the compression spring and the
head of the shoulder screw causes these
extrusions to force the pawls outward,
engaging the starter cup.
9. Apply a small amount of thread locking compound
such as Loctite 242 (blue) to the threads of the
shoulder screw, and install the screw. Tighten it to a
torque of 71 - 89 in lb. (8 - 10 Nm).
10. Install the starter rope by following the steps described in the previous section of this chapter.
11. Install the starter and tighten the starter nuts to a torque of 80 - 106 in lbs (9 - 12 Nm).
Figure 6.10
Pressure Plate
Compression Spring
Pawl
Torsion
Spring