Elektron Analog Four - Manual (Page 95)

Appendix C: CV TRACK PARAMETERS C-1
Appendix C: CV TRACK PARAMETERS
In this appendix, the CV/Gate track parameters are explained.
CV A-D
The CV A-D pages control the signals sent from the 2 dual CV/Gate outputs. Depending on the CV type chosen in the
CV CONFIG menu, the available parameters will change.
CV (GROUNDED)
No parameters available. The CV output will not send any signal.
CV (PITCH V/OCT)
TUN (Coarse Tune) sets the coarse tuning of the CV in semi-
tones.
FIN (Fine Tune) sets the fine tuning of the CV.
BND (Bend Depth) controls the bend depth. The higher the set-
ting, the more the pitch of a trigged note will be offset.
SLI (Note Slide time) sets the CV control of the slide time of note
slides.
SRC (Source Track) selects the track whose notes should be
used for sending CV signals. The CV track, FX track and synth
tracks 1-4 can be used as source.
A note about the LCD graphics: The audio plug graphics in the
CV A-D PARAMETER pages flashes, indicating whether tip or
ring of the audio cable plug is used for sending the CV/Gate sig-
nals the active PARAMETER page controls.