Hangar 9 33% Pawnee 80cc ARF (3 Boxes) - Manual (Page 13)

13 Hangar 9 33% Pawnee 80cc ARF
 4. The cable then goes through the hole in the cable
fitting. Run the cable back through the crimp
 5. Loop the cable back through the crimp. This will
make the cable secure when it is crimped in the next step.
 6. Pull the slack cable taut. Use a crimping tool to
secure the cable and crimp in position.
 7. Thread the cable fitting in the ball end. To make
sure the fitting is secure, turn the fitting 12 rotations in
the ball end.
 8. Repeat steps 3 through 7 to prepare a second ball end
and cable.
 9. Use a 3/32-inch hex wrench and 1/4-inch open-end
wrench to secure the two ball ends to the rudder servo arm.
Position the ball ends so they are 1 1 /
4
-inch (31mm) from the
center of the horn, or in the first hole in from the end.
 10. Use string or dental floss to secure a 36-inch
(915mm) servo extension to the rudder servo lead. Mark the
lead so it can be easily identified when the servo is installed
in the fuselage.