Hangar 9 33% Pawnee 80cc ARF (3 Boxes) - Manual (Page 15)

15 Hangar 9 33% Pawnee 80cc ARF
 18. Secure the cover over the servos using two 2mm
x 8mm sheet metal screws and three 4-40 x 1/2-inch
socket head cap screws. Use a #4 washer on each of the
4-40 screws. Tighten the sheet metal screws using a #1
Phillips screwdriver, and a 3/32-inch hex wrench for the
4-40 screws.
Landing Gear Installation
Required Parts
Fuselage Landing gear shock (2)
Main wheel (2) Landing gear bracket (4)
Wheel axle (2) Shock end (2)
8-32 lock nut (6) #8 washer (16)
#8 lock washer (2)
8-32 x 3/4-inch socket head cap screw (10)
8-32 x 1-inch socket head cap screw (4)
8/32 x 2-inch socket head cap screw (2)
6-32 x 1/4-inch setscrew (2)
Wheel collar with setscrew (2)
Main landing gear (right and left)
Required Tools and Adhesives
Threadlock Light machine oil
Flat blade screwdriver
Hex wrench: 1.5mm, 5/64-inch, 1/8-inch
Open-end wrench: 11/32-inch
 1. Locate the items necessary to install the landing gear.
You will also need the fuselage for this section of
the manual.
 2. Use a 5/64-inch hex wrench to remove the two screws
that secure the hatch to the fuselage. Remove the hatch and
set it aside in a safe location.