Hangar 9 33% Pawnee 80cc ARF (3 Boxes) - Manual (Page 19)

19 Hangar 9 33% Pawnee 80cc ARF
Elevator Linkage Installation
Required Parts
Fuselage assembly 8-32 flanged nut (2)
Control horn with ball end (2)
8-32 x 2
1 /
4
-inch countersunk machine screw (4)
4-40 x 4 1 /
2
-inch adjustable link (2)
Required Tools and Adhesives
Flat blade screwdriver Open-end wrench: 11/32-inch
Mixing cup Paper towels
Isopropyl alcohol Linkage wrench (optional)
 1. Locate the items necessary to install the elevator
linkages. You will also need the fuselage assembly for this
section of the manual.
 2. Slide the 8-32 x 2 1 /
4
-inch countersunk machine
screw through the elevator from the top of the elevator.
Thread an 8-32 flanged nut on the screw. While using a flat
blade screwdriver to hold the screw, thread the control horn
on the screw.
Note : Always use threadlock on metal-to-metal
fasteners to prevent them from vibrating loose.
 3. Use an 11/32-inch open-end wrench to tighten
the nut against the elevator to secure the screw. We
recommend using 30-minute epoxy on the screw as
described in the aileron and flap section of the manual.
Adjust the position of the control horn so it is 1 1 /
8
-inch
(28mm) as shown in the drawing.
1 1 /
8
-inch (28mm)
*Drawing not to scale
 4. Install the 4-40 x 4 1 /
2
-inch adjustable link between
the control horn and ball end. With the servo centered,
adjust the link so the elevator is aligned with the stabilizer.
 5. Repeat steps 2 through 4 for the remaining
elevator linkage.