Hangar 9 33% Pawnee 80cc ARF (3 Boxes) - Manual (Page 8)

8 Hangar 9 33% Pawnee 80cc ARF
 15. Use a 3/32-inch hex wrench and 1/4-inch
open-end wrench to secure the ball end to the servo arm.
The servo arm is located in the inner hole, which is 1 1 /
4
-inch
(31mm) from the center of the servo as shown.
1 1 /
4
-inch
(31mm)
 16. Use a #1 Phillips screwdriver to thread a
2mm x 10mm wood screw into each of the holes to cut
threads in the surrounding wood. Remove the screw before
proceeding to the next step.
 17. Apply 2–3 drops of thin CA in each hole
to harden the surrounding wood. Allow the CA to cure
before proceeding.
 18. Tie the string to the end of the servo
extension. Use the string to pull the servo extension through
the wing to the opening for the flap servo.
 19. Secure the aileron servo cover in the wing
using four 2mm x 10mm sheet metal screws and a #1
Phillips screwdriver.