Hangar 9 33% Pawnee 80cc ARF (3 Boxes) - Manual (Page 28)

28 Hangar 9 33% Pawnee 80cc ARF
 2. Use foam rubber and a hook and loop strap to
secure the receiver in the fuselage. Make sure to plug the
servos into the correct ports of the receiver, as well as
the 12-inch (305mm) extensions into the aileron and flap
ports of the receiver.
 3. Use hook and loop tape (not included) to mount
the remote receiver as far away from the main receiver as
possible. Make sure the antenna on the remote receiver
is positioned vertically in comparison to the horizontal
positioning of the main receiver antenna.
 4. Use a hobby knife with a #11 blade to remove the
covering from the fuselage for the switch harness. Mount the
harness using the hardware provided with the harness.
Note : Multiple locations have been provided
for the switch harness installation. Use a location
that best suits your radio installation, battery
and receiver positioning in the fuselage.
Wing Installation
Required Parts
Fuselage assembly #8 washer (4)
Strut end (4) 4mm nut (4)
Strut pin (4) Strut pin clip (4)
Safety tubing (4)
Wing assembly (right and left)
Aluminum wing joiner (A and B)
1/4-20 x 2-inch nylon wing bolt
8-32 x 3/4-inch socket head cap screw (4)
Strut attachment mount (2)
Required Tools and Adhesives
Open-end wrench: 7mm Hex wrench: 1/8-inch
Threadlock
 1. Locate the items necessary to attach the wing panels
to the fuselage. You will also need the fuselage assembly,
as well as the right and left wing panels for this section of
the manual.