Industrial Data Systems IDS DT200 - Manual (Page 13)

11
3.1.5 CONFIGURE PASSWORD
There are 2 password levels. Password level 1 protects access to the ID functions and the clear
memory functions. Password 2 protects access to the configure and system initialize
functions.
LEVEL 1 PROTECTED FUNCTIONS: ID1, ID2, ID3, TRANSACTION, &
CLEAR MEMORY.
LEVEL 2 PROTECTED FUNCTIONS: CONFIGURE & INIT SYSTEM.
Activate the CONFIGURE menu and press the ENTER key when the DT210 displays 'CONFIG
PASSWORD'.
The DT210 prompts: "EN PASSWORD 1 N"
Enter a 'Y' to enable the password or an 'N' to disable the password. If the password is enabled:
The DT210 prompts: "ENTER PASSWORD 1"
Enter up to 7 characters for the new password. Press the ENTER key to complete the password
entry.
The above steps are repeated for password 2 .
WARNING: ONCE A PASSWORD IS ENTERED IT MUST BE MEMORIZED. IF YOU
FORGET THE PASSWORD THERE IS NO WAY TO ACCESS THE
PROTECTED FUNCTIONS.
The PASSWORD function inserts an additional step when accessing protected functions:
The DT210 prompts: "ENTER PASSWORD".
The correct password must be entered before proceeding.
3.1.0 PRINT DT210 CFG
Activate the CONFIGURE menu and press the ENTER key when the DT210 displays 'PRINT
DT210 CFG'. The DT210 sends the configuration data to the printer. Activate this function after
installation and keep the printout with the DT210 manual.